Posted by NY 986 on October 12, 2013 at 14:39:07 from (67.142.168.142):
In Reply to: good baling equipment posted by alderman on October 12, 2013 at 13:39:20:
Questions. What kind of crop are you cutting and is your baling weather typically humid or are you in the Southwest in a dry climate. Humidity or the lack of will dictate whether you need a conditioner for the hay plus a tedder. I know you asked on a Farmall (IH) board but most of the recommendations will not involve IH hay tools. I liked the IH 1190 mower-conditioner but that is over a quarter of a century ago and it has been said CNH is considering paring back parts availability for such older products. Assuming you need a mower with a conditioner system I would look at a New Holland or 12XX John Deere. As far as balers go everybody has a preference and has a strong opinion but I will say a New Holland or John Deere post 1970 with a couple exceptions. If you can find a dirt cheap NH 461 mower-conditioner and a NH 270 baler you will most likely have a couple of thousand dollars invested. I know people will have stories about how they found a mint machine stowed away in a barn for last twenty years and paid 100 dollars for it but that is far from an everyday occurance. If you need a tedder then figure another thousand dollars and a side delivery rake then several hundred more. Now we have to talk wagons and there figure another several hundred dollars each again. Where this is leading is you may have much more invested than you anticipated. It might be a good idea to find out what the rates are for custom work (for you to hire) in your area and evaluate if owning your own is the best way to go. One thing said for owning your own is when you want to go the equipment is there waiting barring breakdowns. Good luck figuring out your best option.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.