Posted by pete 23 on October 06, 2013 at 10:46:07 from (173.87.1.46):
In Reply to: 'H' Pressure Plate posted by FBH44 on October 06, 2013 at 04:14:24:
I used to rebuild all the Rockford clutch's(not the Auburn) on all the IH tractors & the IH ones also. Replaced a lot of pressure plate springs on larger tractors( usually to get heavier duty ) but never replaced them on an H. Didn't need to.At their age now, they may well be weak though. The fingers used to come in a package with new springs for them. Those springs were most always worn where they hook to finger. In later years everything turned to just putting in a rebuilt one. Problem with the rebuilts is that you never know how many times it has been resurfaced. Sent a few of them back due to lack of engagement pressure from too much material taken off plate. Have even had flywheel step machined to my own liking to make some of them fit up properly. Of course, that messes things up for the next clutch job. Not a fan of much rebuilt stuff but now days not much choice most of the time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.