Posted by Tom Fleming on October 02, 2013 at 04:37:39 from (67.20.233.75):
In Reply to: what to do? posted by jamie majors on October 01, 2013 at 13:24:20:
What most everyone has said is correct. As a matter of habit, I always turn the fuel off and run the tractor until it stops when I am done using it. Whether I am done for the day, or done for the season. Now, I don't do that if I stop for lunch or am at a show, just when I am done using it.
In addition to what each of the previous posts has said, an old timer taught me that if the float sticks, it is easier to get it loose again without taking the carb apart if it is stuck OPEN vs. closed. Also, if you leave it for awhile, the fuel will evaporate out of the carb. Multiple times of that can cause varnish and other nasties to occur. No fuel in carb, no problem. Just remember when you go to start it again, to turn the fuel on, and let it set for a few mins to fill up the fuel bowl.
And yes, you will forget once in awhile to turn the fuel on, and then scratch your head for a bit why the old girl won't fire. BTDT. LOL.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.