Posted by RustyFarmall on September 23, 2013 at 11:18:37 from (216.248.71.226):
In Reply to: Hyd fill level on H posted by Farmallb on September 23, 2013 at 10:36:17:
If there is not enough oil in the reservoir to fully extend the cylinder/cylinders, add more oil until it functions as desired. If you get TOO much oil in it, the excess will spew out through the vent hole in the fill cap and make a mess, but no other damage will occur. If you aren't using the belly pump, it still needs SOME oil in it. You can fashion a dipstick from a length of #9 wire. Just insert the wire, pull it back out, and see where the oil level is. It won't be accurate by any means, but at least you will know there is some oil in there. Add 1 quart at a time until you are satisfied.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.