Farmall & IHC Tractors Discussion Board |
Re: Re: Re: No Start on my H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on December 01, 2000 at 09:48:32 from (206.228.214.232):
In Reply to: Re: Re: No Start on my H posted by farmall man on December 01, 2000 at 08:34:07:
Using our method, we do not know if we are on the compression stroke and are ready to fire or if we are between the exhaust and the intake cycle with the intake preparing to open. If we had earlier determined which is the exhaust and which is the intake valve and we had an assistant to turn the engine to where we could watch the # 1 cylinder valves move we could have watched the intake valve open and then close to where it and the exhaust valve were "rocker arm loose". This would have assured that we were on TDC ready to fire. Since we did not do this and the engine did not run the timing is at the wrong place as is firing between the exhaust stoke and the intake stroke. Moving the distributor 180 degrees will correct the timing to put fire to the #1 cylinder between the compression stroke and the power stroke which is where it should be.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|