Posted by Kirk Affeldt on August 17, 2013 at 18:56:36 from (206.144.217.9):
After getting my new-to-me 340 home and in the shed, I preceded to use PB Blaster down the spark plug holes and let it sit. After a couple of weeks, I jacked up a rear tire and put it in 5th gear to rock the tire. The wheel and engine turned over! I have made a couple of revolutions on the tire and the engine has turned over a few times as well. I have a couple of questions to ask of your knowledge and experience as I am kind of a newbie at the restoration of a non-running tractor.
1. Am I ready to try to fire the tractor up, once I go through the points, plugs, condenser, coil, and starter?
2. Should I be concerned about PB Blaster seeping between the pistons/cylinders and into the oil pan? Will that harm the engine starting it/running it? I used a good half of a can over the two weeks of sitting-soaking.
3. What is a good method for cleaning out the gas tank? There is a kind of damp gritty residue in the bottom of the tank-my assumption rust with whatever is left of gas/gas residue.
4. Since this 340 has a 6 volt system, should I stick to a 6 volt battery or should I get an 8 volt battery?
Thank you for your thoughts and opinions!! It is much appreciated!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
