Posted by PaulW_NJ on August 09, 2013 at 15:33:24 from (72.88.211.158):
I'm finally getting to starting up the C123 motor in my 240U that I rebuilt. Block was tanked clean, new sleeves, pistons, etc. Rocker arm was disassembled, and rodded out and cleaned. So passages should be clean. Oil pump looked fine: I sanded flat the bottom plate & replaced gasket. Oh yeah, I almost forgot: I replaced all rod and main bearings too.
I want to be sure the oil circulation is OK before firing it up. Cranking it (without starting it), I'm not seeing any appreciable oil up on the rocker arm. Which is my concern. Is that normal? I opened the oil pressure gauge port, and oil flows from there when cranking. I connected an accurate gauge to the port, and it goes up to 10 psi when cranking. So I assume it's priming OK. I read it's supposed to go to 45 psi when it's actually running. . . so far I'm only cranking it.
This is my first major rebuild, so don't know if what I'm seeing is a problem, or not. Appreciate your advice.
This post was edited by PaulW_NJ at 15:55:31 08/09/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.