Posted by chad from michigan on July 30, 2013 at 03:30:58 from (70.39.231.100):
First of all thanks to everyone that has been helping me out. I had time to hook a test guage between the hydraulic manifold and the IH-1000 loader last night. With it hooked up no load on the loader the touch control lift arms made the pressure run 200-300 psi. if you ran the loader it would run 200-400 psi. If you ran the loader all the way up or tilted the bucket all the way down or all the way up till they wouldn't go anymore the gauge would peg out at 1000 psi. should I have more Psi through the whole range of motion? I asked my dad to test it with a load of dirt today since I didn't have time last night. I do know that when the bucket has a scoop of dirt in it it will only lift 2' off the ground. The loader on my Farmall 100 has not problem picking up a full load of dirt heaping over the sides. I know something isn't right. Does these pressure sound about right? Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.