Posted by Dr. Evil on July 27, 2013 at 11:25:25 from (70.194.132.2):
In Reply to: Roll-a-matic posted by Ellis Kinney on July 27, 2013 at 10:02:29:
I've spent a L-O-T of hours on Roll-a-Matic NFE JD's, much prefer them to WFE's. With the developement of anti-kickback power steering the R-o-M frt end wasn't as needed, like say when turning into a plow furrow from the land, w/R-o-M, one frt wheel steps down into the furrow, then the other, no jerking the steering wheel out of your hands like a solid NFE will do in the same situation. But P/S eliminated the problem. They do ride nicer than a solid frt end. Only problem was they couldn't carry as much frt weight as a solid frt end like big frt mount cultivators, loaders, etc. And they didn't like to be "Dropped" if you got the frt wheels too high for whatever reason. Makes changing a frt tire much harder, you needed a much taller block of wood to drive the good tire/wheel onto.
I think IH missed an opportunity by NOT taking the R-o-M when offered.
I have thought about making a "sprung NFE" for an H or M. Two sections of heavy wall square tubing, one smaller to slide inside the other. Then insert a std car shock absorber, or maybe an air shock inside the two sqr tubes. Would allow the frt end to cushion bumps and holes, but wouldn't work as well on loader tractors, too much weight variation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.