Starting at the back of that shaft, I believe it has a flange that the rear bearing rests against, then you have the bearing and the gears and spacers stacked along the shaft until you get to the front bearing. Then the alignment joint goes on the outside with a capscrew into the end of the shaft. Make sure that capscrew is in place and tight.
If that is all OK, the outer race of the front bearing inserts into the housing from the front with a 2 piece retainer clamped onto both sides of the bearing. I don't see a way that assembly could be loose and allow the shaft to move back (probably forward though).
The only ways I see (other than the above mentioned capscrew) for the shaft to move back is if the front bearing itself has failed and is allowing the shaft to move or the shaft itself has some major failure.
It looks like the rear bearing supports the shaft but does none of the fore/aft positioning. Unless the shaft itself broke, it looks like your problem has to be at the front, all accessable at the input joint. Adding spacers would push the gears and rear bearing farther back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.