Well, I know a solution and a suggestion, but it is not cheap. There is a company in Greensburg, Pa. that I used for the KB5 tank. Their process is simple: bake the take to burn off any previous coating, varnish, paint, etc. The sand blast it then. Put in a perm epoxy coating and give it back. They will also repair any holes, rust, etc. Excellent job, excellent company. Sit down now..................my KB5 tank was $300 for the service. I am VERY pleased with the result and the quality. Now, I am also only a 30 minute drive from them, so I didn't have to pay shipping both ways.
If you are absolutely looking to do it yourself, all I can say is it depends upon what they used to coat the tank. You can try acetone or MEK to dissolve it. If that doesn't work, you are going to have to bake it out. Rust is easy, muriatic acid, then triple rinse with water, then rinse with acetone. I use Caswell Epoxy tank liner, which also isn't cheap, but it is absolutely the best on the market.
so, your pocket book will dictate how you proceed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.