Farmall & IHC Tractors Discussion Board |
Re: Remote Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John In Iowa on November 22, 2000 at 06:22:01 from (199.108.164.13):
In Reply to: Remote Hydraulics posted by TLK on November 21, 2000 at 14:22:44:
IH made a remote valve that mounted on the top of the fill pipe to the belly pump on the M,H, and MD for the liftall for 2 way hydraulics. This was before the engine driven pump that was on the super and intermediate M. This was hookup to the outlet and dump back in the reservoir in the pump. In order for it to work you had to keep the single lever pull back. Most of this time this was done by tying the lever back. At one time they had a attatchment to do this, but this got lost in most cases. John In Iowa
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|