sry on the wait. I use the widest point/spray pattern available. Depends on your rig, some have interchangable tips, my new Brigss & S has an adjustable fan tip. Use widest. If that is not doing the job - get closer. You want to get under the edge, so come from different angles (left then right). NEVER SHOOT UP! If doing standard clapboard, you may have plaster and a big mess inside! NO joke, been there. ON outbuildings, maybe watch for feed bins, old electrical etc. Hold at about 45 degree angle,approach from about 6-12 inch out and come in to about 2-3 inch. Do not come straight in as this will probably leave "gauges", sweep in from the side. 20 minutes practice will tell you more than I can here. You will consume water. Plan for that. You really want to get off the dry rot as well as the paint. I will post pic's if I can. Hand painting oil primer will ensure that all the rough edges are covered, or far better than spraying.Just does a far better job of sealing up the edges. Top coat can be sprayed. HEAT GUN -only for really ugly details in very high visability spots,like main door trim to house. Be very careful, I use the air gun type from harbor freight, $10. Heat only to point that you can scrape off, 10-15 seconds. BTW-this type of heat gun can be used for other stuff, life frozen doors locks, softening up heavy grease, etc ps- the single point on your high pressure washer will cut through your walls very quickly. I use mine for digging holes for pole barns,no joke.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.