Posted by Grabatire on April 26, 2013 at 21:20:50 from (216.238.225.102):
Changed the head on a 1953 WD9 because the original was cracked. Had the replacement head checked and resurfaced. Now there is water getting in the oil. That didn't appear to be the case with the cracked head still on the engine.
I notice water seeping out above the rear engine mounting plate so I suspect an expansion plug has rusted through on the back of the block. Is there any way that water can get back into the crankcase from that area other than the rear main seal or perhaps past the expansion plug at the rear of the camshaft?
There is no sign of a faulty rear main seal either.
I seen the engine run before the old head was removed, but I hadn't noticed the water coming from the rear. It probably was, I just didn't notice it.
The engine was extremely rusty inside the water jacket. In fact the water baffles were completely destroyed and there was an inch and a half of sediment in the bottom. I hope the block didn't rust through into the crankcase!!
The engine is coming out tomorrow to deal with the leak at the rear. Is there anything I should be looking for other than what I've mentioned above? Dave.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
