Plain old Delco 10SI alternator works just fine at low RPM.
No need to cut the hood either. There's plenty of room.
There are advertisers in Red Power magazine that sell a complete kit including a bracket that positions the alternator. If you're starting with nothing this is probably the way to go.
If you have a generator bracket, you just need to know a couple of simple tricks to make it fit:
1. Install the generator bracket upside down.
2. Use 3/8" all-thread to mount the alternator ahead of the bracket.
3. You may need to hacksaw off a small bit of the lower mounting lug on the alternator to get the belt to line up, or shim it out with washers, depending on the alternator you get.
4. You may need to grind a "divot" in the front arm of the bracket to get the alternator to sit right.
5. The stock length belt works fine with the alternator.
6. The back half of the alternator can be "re-clocked" so the wires point out in a convenient direction. Just remove the bolts and carefully rotate the back half 90 degrees, then put the bolts back in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.