Farmall & IHC Tractors Discussion Board |
Re: M overbore
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on November 13, 2000 at 20:12:53 from (216.196.12.156):
In Reply to: M overbore posted by Bryon on November 13, 2000 at 11:28:20:
Everybody has there owen preferance ,myself ilike the 8500 ft. high alitude pistons ,one of my customers has a S/MTA with this setup we just over hauld it two years ago first time since 1958 when it burnt under a picker that is when they put the first set in it , had a hard time finding the same pistons for it ,but after calling Clyde Burkshire we found the and completed the job . It has more H/P the his 706 gas with the 291 cu.in .It handels my 2300 A/C disc wy better then my S/MTA and mine has 68.5H/P ,they use it ever day on there farm that tractor is awsome on the feed grinder you can'tkill it
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|