Farmall & IHC Tractors Discussion Board |
Re: Re: Re: INFO ON A FARMALL B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by redhead on November 13, 2000 at 08:52:47 from (63.28.42.160):
In Reply to: Re: Re: INFO ON A FARMALL B posted by BART on November 13, 2000 at 08:07:46:
A high crop H/M or a regular C too. All three of these are higher(5-10 inches) and wider(100+ inches total) than a B. Although, I think the HV is somewhat rare. And, hydraulics were not standard on these models either until later years. You should post a message asking Guy Fay to get involved in this. He has a wealth of spec. and production # knowledge. Also, you might consider an AV: wide front, hydraulics on Super models, adj rear to 68 inches, and probably the highest production numbers with high crop option. I don't know if an AV is higher than a reg C. If not, reg C's are plentiful and wide fronts are available. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|