Posted by John A. on February 14, 2013 at 21:00:59 from (64.128.16.238):
In Reply to: Wheel Weight Bolts posted by IAtractorKid on February 14, 2013 at 13:03:38:
IAtractorKid, Hopefully your wheels are Dished out! and set pretty wide, on 80 inchs or better! IMO set yourself up to be able to add more wt later on if you need to. Don't shoot yourself in the foot here. *Use a full lengths of All-thread for this project. * Need 4/Wheel x 2 = 8 total Why a full length,, Use 1/2 wt sets on the inside and full 1 piece wts on the outside you should be able to......... put as many as 4 or 5 / side of a given wheel, 8 to 10 total / side of the tractor My 966 has a single, 750 lb aftermarket wt on the outside of each rear wheel they have never worked loose! IMO the single all thread is easier to deal with in the long run over the smaller individual wt blots and nuts! Hope this helps. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.