Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Super C remote hyd.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on November 06, 2000 at 05:05:04 from (207.172.106.171):
In Reply to: Re: Re: Super C remote hyd. posted by Karl in MD on November 05, 2000 at 21:42:42:
You want the valve, which bolts to the side of the touch control housing where the current manifold bolts on, then you need the manifold from the donor tractor since that now bolts to the valve. Then there is a handle and bracket that he mentioned that mounts on the headlight bar, and the connecting arm from that to the valve. Yes the valve is a two way valve. There was also an aftermarket casting about 1" thick that goes between the manifold and the touch control assy that reroutes the pressure side out through a loop so that you could use an external aftermarket valve, but they are hard to locate (only seen two of them myself). Another possibility might be to call the folks at Saginaw County Tractor (they sell 3 pnt hitches) and ask about their solution for the C. I haven't seen it, but understand they offer something to plumb hydraulics to their 3 pnt hitch. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|