Posted by IH fan on January 05, 2013 at 11:13:13 from (108.220.170.72):
In Reply to: Hydraulic piping posted by Alderman on January 05, 2013 at 10:58:37:
Alderman said: (quoted from post at 13:58:37 01/05/13) Same engine....pump is on the H already
I had "assumed" if you had the 3 point, you already had that part worked out. Also I took it the loader had it's own integral valves and reservoir. Problem is, if the 3 point valve is not "pressure (or power) beyond", you will need a new 3 point valve that is PB before the loader valve will work. And, yes you should take the plug out of the top of the 3 point cylinder and put a breather in it. It is for pressure in the opposite (down) direction and if it's plugged, all you do is pressurize the air in the rod end of the cylinder or it might be leaking by the rod seal.
As I said, you could add a "priority flow divider valve" and split your flow, part going t the 3 point valve and part to th loade valve. problen is, you are already borderline on enough flow to operate the loader and robbing part of it to go to the 3 point and it will be extremely slow. that's what happened on my 240U and someone added a crankshaft dirven pump for the lloader. You can tell by the plumbing that it had been using the tractor pump before PS was added and whoever had it before had added the second pump. On mine, the "priority" side takes away enough flow that the 3 point will not work when the engine is idled down. Your situation would be even worse than mine because you would need to split the flow about 50/50 for both to operate and losing 1/2 your flow to either and that doesn't leave much.
With a pressure beyond valve, you will have full flow avaiable to both the 3 point and loader, unles you try to operate both at the exact same time.
This post was edited by IH fan at 11:15:47 01/05/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
