Farmall & IHC Tractors Discussion Board |
Re: Farmall 400 Dieseling: Doggon It..
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Maybe, Just maybe... on October 29, 2000 at 07:23:39 from (209.172.217.170):
In Reply to: Farmall 400 Dieseling: Doggon It.. posted by Jon on October 28, 2000 at 19:52:42:
its gonna work this time. I did turn it to TDC, then have it fire #1 cyl, instead of at the 25 degree mark, I misunderstood the manual on that one. Then I went ahead and pulled the carb and made sure all passages were clean. There was a little bit of build up in the Idle Mixture. I put it back together and she took right off. It was still missing some at Idle with the Idle screw one turn off, so I turned it all the way in and she stopped missing. I ran it for 10 minutes or so at various RRM's and it seemed to run even at all of them. I shut it off and there was no dieseling. Later on today if I get some time I'll run it awhile longer to see if it will diesel or not. Thanks for all yer help!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|