Farmall & IHC Tractors Discussion Board |
Re: SMTA Remote hydraulic valve
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on October 25, 2000 at 22:14:39 from (208.49.9.231):
In Reply to: SMTA Remote hydraulic valve posted by Dan on October 25, 2000 at 17:59:35:
Dan & Haas, Will try to get some pics this weekend of the remote valve I have added to my M to run a two way cylinder. The latch you talk about is mounted along with the original liftall control rod. When you want to use your remote lever, you just pull back (Towards the operator) on the original liftall control rod and lock it into the latch thus activating the liftall pump. Then you control the remote cylinder with the other self-centering control rod. I don't think there are any bushings in the remote apparatus but could be wrong. Haven't had any leaks in mine at all. Will try to get the pics asap.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|