It's hard to get accurate readings with the equipment they use and the relatively small numbers being measured. The PTO dynos are only good for relative comparisons of tractors on _THAT_ dyno. (As Tractor Vet illustrates) A 3hp error is 10% on a 30 horse tractor and 10% error either way is unacceptable from a scientific standpoint.
Weight, weight distribution, engine torque and powertrain momentum all contribute to pulling performance.
At the temple tractor show I always see a crowd gathered around the dyno as they "test" various tractors. I went and looked at it during the lunch break and noticed that with no tractor hooked up at all, the battered looking needle on the gauge was showing 10 hp. How meaningful was any reading on that dyno? Pretty worthless if you ask me.
Attention to detail can make one run better than the other. You can have a 281 with propane head and this and that, but if the valve job is poor or if the rings aren't sealing it won't do you much good. Carefully assembled and tuned stock parts can make a big difference.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.