Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Farmall 400 dieseling: Update #2
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Don't I feel stupid on October 24, 2000 at 16:31:31 from (209.172.217.167):
In Reply to: Re: Re: Re: Re: Farmall 400 dieseling: Update #2 posted by Jon on October 24, 2000 at 15:38:04:
After making the above post I went down and looked at the 400 again. I noticed the distributor didn't look like it was in the same position as before. I pulled the cap off and realized I had forgotten to tightened down the dist bolts and it had worked its way out of time. I retimed it on the 25 degree advance mark, tightened down the bolts and fired her up. Came right to life and purred like a lion :) Went ahead and ran it at high idle for 30 sec to a minute then brought it back to ideal for a while, no missing at all. I turned the key off and it shut off with NO dieseling at all. So I guess I have found what the problem was. Thanks for all your help and everyone elses. I'm sure in another few days somthing else will arise and I'll be back on here ;)
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|