Posted by Dan MD on November 13, 2012 at 18:24:24 from (69.179.26.186):
I don't know if you saw my earlier post, but I was hoping you could listen to my SMD Flutter video and tell me what you hear? I think it has an abnormal flutter unloaded and mostly in the mid to upper RPM range.
http://www.youtube.com/watch?v=P3S3uhHSEJ0
In this video you can head what I am talking about about half way through when I up the RPM. Also, at roughly the 10 second and 45 second marks, I load the hydraulics for a few seconds.
Since this video, I pulled the injectors lines and ran the lines into 4 seperate containers and ran the engine on gas for a few minutes. I collected 316cc, 310cc, 310cc and 320 cc respectively. I believe this range is in spec for variance between cylinders. One thing I recently thought about was if my 450 open face injectors might not be set correctly for my SMD pump. They pop at 850, 900, 850 and 850.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
