The link is to Carter and Gruenwald in their Links tab, there is a connection to Wiring diagrams. If you have a new or rebuilt starter, it should not burn out. Many YT contributors have had 6v starters in 12v equipped tractors for decades (we have probably 6 of them) that have had no failures. Starter drive failures are the most frequent, but rare, event. Starters fail from burnout (not bearing wear or brush wear) from two issues: running after startup. (like holding the key on start for 20 seconds after the engine fires) OR: from prolonged starting effort on a reluctant tractor engine. The duty cycle of a starter motor is about 20 seconds with 3 to 4 minutes between start attempts. If the engine is difficult to start, it needs to be tuned to start better. If it is a puller, and tweaked to unreliability to win, it still should start easily with 00ga cables and a 1000 CCA 12v battery. Our tractors usually start after the second piston comes to the top. The starter wear is dramatically reduced because they start instantly. Tell us about te way yours works. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
