Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Throttle/Governor on C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on October 19, 2000 at 18:37:00 from (64.24.62.58):
In Reply to: Re: Re: Re: Re: Throttle/Governor on C posted by FC on October 19, 2000 at 15:38:19:
I think it could behave this way. An engine at half thottle isn't exerting as much force on the flyweights as it would at full thottle which means the spring doesn't have to work as hard to hold it open. If you think it might be out of adjustment, a basic place to start is, with the engine off and throttle lever at max position, to adjust the gov-carb linkage so the thottle is wide open--no RPMs means no centrifugal force means no resistance to spring whichs means the spring will yank the throttle wide open. Just a question--are you not able to physically push the lever to the max position? If so, have you verified that the RPMs at max throttle advance are too low? Good luck, Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|