Posted by Lmack on October 17, 2012 at 20:28:00 from (24.131.58.167):
In Reply to: Re: Farmall 230's posted by IH fan on October 17, 2012 at 12:23:05:
To use the earlier front mounted implements was simple enough by just switching the rockshaft control arm for the cylinders. The front cultivator frame mounts, side dresser mounts, planter hopper mounts and the chain planter drives were identical to the SC and 200. A long control rod was needed to extend to the rock shaft for the cultivators to control the planter drive clutch. Other implements such as corn pickers required a special kit to change from the C style touch control to the Hydra Touch. My Uncle had a 240 with the Hydra Touch and I never liked it (We had a 200). Seemed like depth control was not as positive. The two point was improved for the 230 over what was used on the SC and 200.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.