I tune motorcycle/powersports engines as a good part of my living and farm which, I have some old tractors mixed in. A 460 is one of them. In my business jetting being spot on or off is the difference between a seized engine or melted piston, or an engine that will lead a healthy life. I use the same skill set to tune my old tractors. Now an old tractor can be fairly forgiving and can be hard to always get a good read on a spark plug, and they don't have as good of carburetor as most of what I normally deal with. However the same principles exist in a gasoline engine whether it is a generator or a pickup truck or drag car. I will not deny the newer fuel is bad, I will also not deny that it is possible to get a header red hot and still not ruin the engine. What I don't agree with is the fact that you cannot tune an engine to run on this gas today or all the stuff you in particular spew about how everyone needs Hi-Test in their old tractors. I have responded to a few of your posts about this over the years and I have never ever seen you reply with mathematical proof that these old tractors need such high octane provided the fuel mixture and timing are set properly. Just about everything that happens in an engine has a math formula to explain it. Needing high octane gas is a product of your compression ratio, cam, combustion chamber and so on that makes up your cranking compression as well as the ignition timing. So how do these old engines with 7 or 8:1 CR end up needing 97 octane???? Teach me, I want to know. Maybe you push your compression ratios or ignition timing or some other factor but I can tell you your theories do not line up with any part of engine science and I have a 6 cylinder IH that runs like a top on Regular gas and it's used often and I don't mean tractor shows.
Show me the numbers and math behind what you tell people and I will let you be.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
