Posted by P and R Pete on October 11, 2012 at 14:17:01 from (173.86.14.68):
One last chore before I get my FIL"s 450 back to him...
The throttle has no response until it"s moved fully a third on its 90-degree arc. The only adjustable piece is in the second link of the four pieces that deliver throttle motion to the "speed-change lever" of the governor. Lengthening this piece by its unthreading moves the governor-speed-lever closer to engaging (with the throttle kept all the way on "idle"), which has resulted in some improvement, but I"m at the practical limit of its "unthreading" with some ways to go to get more immediate response from the throttle.
I see nothing within the governor that is adjustable, though my I&T manual suggests checking "synchronizing the governor-to-carburetor" linkage within the connecting rod housing.
All the link-ends are rods with the ends bent 90 degrees going through holes in the links, and held in place by cotter pins, which may lead to a bit of slop also, and maybe some delay-in-throttle-response is pretty normal. I can live with that. but I"d like to know if I"m missing something, because I"d worry that a delay in response means I"m not getting close to the top-RPM capability of the engine.
Any thoughts?
Second, I was going to check his valve adjustment before calling it a "wrap". I have an IH sheet that shows a "simplified valve adjusting procedure" in which all 8 valves can be adjusted with only two movements of the crank, at #1 TDC and at #4 TDC. Help me with a reality check- is not #4 TDC exactly 1 and 1/2 revolutions of the crank?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
