Farmall & IHC Tractors Discussion Board |
Re: Changing rear tires on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomH on October 17, 2000 at 16:12:22 from (206.99.145.166):
In Reply to: Changing rear tires on H posted by PatB on October 17, 2000 at 15:44:59:
Just did this last week, so the memory is fresh. - Spray all the nuts with a good penetrating oil (like PB Blaster). Spray them again the next day. - Get wood blocks for cribbing and use a hydraulic jack so you can adjust the tractor up and down. - As Red said, get a long extension for a breaker bar (you'll probably destroy a ratchet, use a breaker bar). You risk breaking the socket or the bolt, but that's not a big deal. Be prepared to grind nuts off if they are rounded. - Best is to have another tractor with a front loader handy to lift the tire/rim; especially if there is fluid in it. Otherwaise have several pairs of arms to help. Don't work alone. - Rim should come right off the wheel. If it doesn't, hit the tire with a sledge hammer or gently pry it off with a pry bar. Once the clamps are off you can use the weight of the tractor and jack to break it loose but they usually don't put up much of a fight. - Be careful, a tire full of fluid could weigh over 600 pounds. And don't break the valve stems.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|