The trick is to get all the "mechanicals" done first, test & run for a while to get all the pesky lil oil leaks & seepages fixed before re-paint.
Total costs will vary as to what you are able to perform yourself, and then what a rebuild or repairs will cost for each item.
It's tempting to just get it all done at once and get it all red, but you will find yourself noticing every shortcut you took along the way. It greatly depends on how far you & your wallet want to go, and how you wish to use it, a good looking work tractor, or a show queen.
Either way, I would begin with getting the engine, tranny, brakes steering etc. fixed properly first & go from there as you can afford.
There are many places on line that restore tractors, I would begin by getting a ball park figure from them, again sight un-seen it will be a ball park figure at best, once you get them apart many things that were un-seen before, need repair, you will also be paying their hourly labor rate, this is good in the fact they know how to get it right the first time, have the experience in repair , painting, tools, and have a long list of places to get the right parts. Most are very reasonable compared to a modern dealership, and actually care a great deal for what they do.
If you can perform many of the repairs yourself & save a great deal and it gives a great amount of satisfaction when completed, but be prepared for some long hours, the ability to withstand the patience robbing pitfalls you find yourself into when the book doesn't quite cover everything, and you end up taking it back apart two or three times to get it right, this is when an experienced tractor mechanic comes in real handy, they can provide the minute " tricks of the trade" that only come with experience. It's a trade off..... of money well spent, to money spent once maybe twice on the same repair, painting is whole nuther ball game, proper preparation is key, any shortcuts will outshine the best of paint jobs, again..... be prepared for long hours & ocaisional re-do's.
This post was edited by rhtx55 at 09:22:32 10/06/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
