Posted by sandegj on September 27, 2012 at 03:16:53 from (69.19.14.34):
I need a little incite from someone that has more knowledge than what I have. I have owned my 1940 Farmall H since 1975 s/n 39402 and it always burned oil #2 cylinder. When I bought it, it wasn't running, I had to replace a broken hub clamp, replace the mag caps points condenser, then plug wires and spark plugs. Had to rebuild the carb just to drive it home. It had a rod knock so I slipped a set of rod bearings in it. Through the years I rebuilt the head #8043 with new valves, guides, and springs. Install a small diameter alternator what was used on Chrysler products and also used there solid state regulator. Later in time as the magneto got weak, I bought a distributor 90 degree angle, which was junk, so I took a 360 ci Chrysler distributor "no vacuum advance" and machined it to work then filed every other lobe off the reluctor and used every other terminal on the cap. I used a Mr Gasket spring kit using the light springs which brings the timing advance close to the production curve. I used the Chrysler E.C.U. also. Enough history. I want to put a 1956 crop row 300 engine s/n 57639 into the H chassis and found some differences. Mainly I bought a 1940 H distributor/ Mag drive and found the bolt pattern was smaller than what was used on the 300 front cover. So one of my questions is, can I put a "H" front cover and cover plate on this 300 engine ? Crank seal the same or different ? Pulley the same or different? What other differences will I stumble into. Thanks Jerry
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
