Farmall & IHC Tractors Discussion Board |
I Tried To Fool The Red
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Old Red H on October 15, 2000 at 08:50:04 from (63.106.153.65):
The Red neglected me in a damp barn for the last year. He decided to try to start me yesterday and I was determined not to run. First I let my battery run down. So he charged me for 1 1/2 hours so I could crank. Then I wouldn't fire. So he pulled the distributor cap and found corrosion on the distributor posts and rotor. He cleaned that up and I still wouldn't fire. So he pulled the points and found corrosion and pitting on them. He took a file and cleaned them up and reset at .019. I fired right up. But I was bound and determined not to move. So I had my clutch plate stuck to the flywheel. The Red idled me and jammed it in first gear with the clutch pedal depressed. Durn if the clutch pedal pulled off the flywheel and everthing was working. So he ran me for an hour and paraded around the farm. Look for the little things after sitting for a year.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|