Posted by oldtanker on August 27, 2012 at 16:40:18 from (66.228.255.239):
Did the job today after looking it at last week. What I thought was going to be an hour to 1 1/2 hour turned out to be 4 hours, she kept showing me more and more. I had told her 50 an hour. I found 3 chunks of 3/4 inch cable but never got tangeled in it. Was cutting brush and small trees up to 3 inched that were 2-3 feet taller than the hood on my M. She followed me around as I cut but I did make sure she was back far enoguh to be safe.
When I finished she wanted to talk a bit. She told me what a great job I did and that she was supprised that I didn't argue with her. I told her as nice as I could that she was known to be a micro manager, out spoken and like to give orders and that I knew that when I agreed to do the job. She paid right away, in cash, tossed in a 20 as a tip and ask if I could do it againg in the spring once the sumack gets up about 12 inches and fall next year.
Onlt problem I had was a screw vibrated out from the ballist resistor so I did a farmer quicky repair with a cotter pin using pliers to twist the pin tight enough to hold the wire in place so I could finish the job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
