Posted by Chuck R in TX on August 25, 2012 at 08:47:43 from (76.253.165.86):
Nearing the end of my restoration and was mounting a new 550x16 tire and tube to front wheel and encountered something that puzzels me. As I inflated the tube after mounting, the valve pulled out of my hand back into the wheel. The tube and tire were bought supposedly as a matched set. I thought that somehow I must have had the tube in backwords with valve facing away from rim hole so I took it off and remounted on correctly, although I think it was ok the first time. (The tube looked exactly like the one removed). It did the same thing but I used an extension so that I could hang onto it. I inflated and deflated a couple of time to get everytning strait inside. Although it pulled hard I got it done and installed the wheel. After about four days the tire went flat and sucked the valve back into the wheel. What am I missing?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.