Farmall & IHC Tractors Discussion Board |
Re: Crank journal diameter ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil Auten (TX) on October 10, 2000 at 04:22:02 from (206.175.72.226):
In Reply to: Crank journal diameter ? posted by Ralph Kramden on October 09, 2000 at 16:04:29:
Ralph, Just pull the crank out and take it to a machine shop. The machinist can check the crank journals with a micrometer and tell you if they are within roundness tolerance. If not, the crank will need to be "turned" on a lathe to get the journals round again. If the crank is out of round and you use it like that, the new bearings won't last long. Also, if the crank has been turned before, it should be stamped with the undersize dimensions on the crank somewhere (10x10 will indicate that the rod and main journals were ground to .010 undersize). The machinist is your best friend here unless , of course, you are a machinist yourself! Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|