Dave_Id said: (quoted from post at 15:48:11 08/22/12) Try switching over the wires on the amp meter. A six volt system used a positive ground, and I assume you switch over to negative ground with the alternator, but forgot to switch over the ampmeter. I did the same thing when I switched over my M.
Thanks... I actually never thought about that. This conversion was already done before I bought the tractor. I took the ampmeter apart ... there is practically nothing in there.
The posts to which the wires connect are connected to a piece of aluminum that is bent and routed down around I guess a magnet, that rotates on a little shaft allowing the magnet and attached pointer to rotate... no connection.
The aluminum is intact so it should have charged, but it didn't, I lubed the shaft a little with some wd 40, put it back together and hooked up a couple wires and touched it to the battery posts ... in both directions ..... nuthin'
durn
This post was edited by realolman at 17:19:32 08/22/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.