Go to the Paint and Bodywork forum on this site and read it for a couple of days, all the info is there, then ask questions about what you don't understand. An oversimplification is take all removable parts off, take everything to bare metal, clean the whole tractor throughly, final prep step is wax and grease remover. Then 2 coats of epoxy primer, sandable surfacer over the epoxy on only the sheet metal (use body filler, etc first), sand and reapply as necessary, then 3 coats of topcoat paint. Epoxy, surfacer, and topcoat are to be mixed EXACTLY as the instructions say. Use hardener only if you have a supplied air system, the hardener contains isocyanates that a charcoal mask will not filter out. They can make you sick. All of this and then some is on the Paint and Bodywork forum, books won't do you much good as many of them are incorrect. I wouldn't pay much attention to paint salesmen either. I am not familiar with your paint. There are several choices, in the order of quality and price, high quality first: Urethane (MUST have hardener), acrylic enamel, acrylic modified alkyd enamel, and the old alkyd enamel (junk compared to todays paint).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
