Posted by Jimmy in TN. on August 18, 2012 at 12:45:39 from (71.88.3.210):
Hey guys don't give up on me but I am still working on this governor on this super c when I can,every thing checks out ok ,New thrust bearing,governor spring is good, weight and pins are good, bushing are good but I still don't get any thrust when I open throttle up ,it will rev up slowly and will not respond when in a pull, here is my question,the shaft that goes through the gov.the end next to the radiator according to the IH8 manuel,fig,390 says there is a thrust spring and a thrust pin lenth ways in the end of the shaft,I guess the pin holds the spring in, I can not tell, if there is, how does it come out? this tractor was running fine when I shut it down, the next time I started it up,problems,so what ever happend it happend all at once. everything else is checking out good Thank you for your help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.