Posted by oldtanker on August 09, 2012 at 22:08:01 from (66.228.255.239):
In Reply to: timing by ear posted by picassomcp on August 09, 2012 at 20:57:03:
Before anytimeing adjustments are made the engine should have a tune up!
Actually on older engine with vacuum advance the timing will not be right with a light before the engine is broke in or after the engine is worn enough to have lower vacuum levels. Worn timing chain makes the problem worse. Best cheap way to time em is hook up a vac gauge, advance the timimg until max vac is achieved and back it off 2" (LBS to people that don't know that vac is measured in "). On newer computer controlled engines get it close and the computer takes it from there.
On mechanical advance if anything is worn, timing chain, springs, weights or pivot pins you are not going to get it right with a light.
I can't begin to count the number of timing adjustments I've had to make to get peoples cars run right that they timed by ear!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.