Posted by Roger46 on July 25, 2012 at 15:31:11 from (70.198.2.40):
I have a Farmall 350 Diesel that I completely rebuilt several years ago. The problem I have had since then (and seems to be getting worse) is that when the head was reworked at the machine shop they didn't do anything with the valve push rod tubes that go through the head to keep them from leaking oil. Six of the eight leak to some extent with oil running down the side of the engine. I looked in the parts manual and they don't show any seals or o-rings. How are they sealed in the first place? Does repair require removal of the head? I took the valve cover off (not an easy task with the power steering unit overhead) and cleaned around the tops of the tubes and put a layer of gasket cement around the top of each tube and it stopped most of the leakage, but it is starting to leak more again. Any advice would be appreciated. Roger
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.