With out seeing what ya got as for pistons and not knowing what the ing. timing is set at or if the centrifugal advance is sticking or not and like Pete said plug heat range and one other small little thing here your gas . If the timing is set tofar advance or to retarded to far and low octane fuel and idle set to high will cause this. So first check what plugs ya got in it ya do not want HOT plugs like D21's or D18's I have the best results from either 3116 or 386 Autolites or C86 A/C's Next check timing and see where it is at and do this at full throttle and set for 27-29 degrees.Check engine idle and set low idle at 450 -475 . While ya got the plugs out look in the hole and see how far up the piston comes , If the dome stops half way up in the spark plug how ya got normal domed pistons IF that dome goes way on put ya have the hight alt. pistons and here your going to need to up the octane rating of the gas ya burn . Check the cent. advance and make sure that it is working and not sticking in retard .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
