It is unlikely that a copper washer would do the job because it is not an acual plug. There is still path to seep oil between the screw and jam nut threads.
I just took a WD-9 steering box apart last year. The tractor had spent much of it's life outside and I noticed in winter that the steering was frozen so it had some water in the steering box. That may have contributed to the oil leak since it was overfilled with oil/water.
Just my opinion here but it is really hard to completely stop all oil leaks on these old tractors. I have read posts from other members and even on completely rebuilt tractors they still have some minor oil leaks. The trick is to figure out which ones can be obviously fixed, like worn bearings/bushings/shafts. In the case of your steering box it probably wouldn't hurt to take the side cover off, clean it out, and replace the oil. While you are at it, it is a good time to change the seal on the output shaft because those do seem to leak too since they are the old leather seals. Maybe you can seal the adjusting screw & jam nut with some of your favourite sealant.
I have a WD-9 with pinion shaft seal leaks right now and the brake bands are a mess. I was going to change the seals and after I took the brakes apart I found the pinion bearings are in bad shape too so I put it back together until a time when I can get by without that tractor for a few weeks. Those will be a pain to change. How do they look on your tractor?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
