One reason I enjoy restoring tractors is compared to any newer equipment, they are very easy to work on. The trick is to realize when you are in over your head & seek professional help. Is has been my experience any fellow tractor collector is more than willing to help, since at one time or another we have all been there, staring at a rust bucket trying to figure out where to start. Your tractor looks to be in very good condition, compared to some.
Experience is the best teacher, do what you can and are comfortable with. If you aren't sure, or have no idea where to begin, it is money & time saved to ask someone with more experience. Service & owners manuals certainly help establish a basic knowledge of the tractor you are working on, but I am afraid jumping in & getting your feet "wet" is about the only way to learn.
There are inherant dangers when dealing with these beasts, they were designed & manufactured to last long after they were paid for, and heavy metal is the rule. A part or piece may look light enough to handle, but beleive me..THEY AREN"T.
A vast array of large wooden blocks, a heavy cherry picker, and a stout hydraulic floor jack would be meager beginings after a handy set of both hand & air tools. BUT if it was easy everyone would be doing it, if you want a tractor the caliber of Colby's excellent restoration seek professional mechanical & paint help.
I don't think you will have any problems with redoing the sheet metal, electrical, and minor repairs. If you mess it up seek experienced help. Like my Dad used to say "Some things in life are "better" learned the hard way."
I don't quite agree with the frustration that comes along with that, but one thing is for sure, you never forget something you learned in this fashion. It takes a lot of patience, some things you may have to tear apart three or four times to get it right, but be cautious, after you finish the first one, you will start looking for another project.
So look her over carefully, find a place to start & dig in.
This post was edited by rhtx55 at 10:37:52 07/14/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
