Farmall & IHC Tractors Discussion Board |
Re: Re: Trailer for tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on October 02, 2000 at 19:03:45 from (129.37.117.36):
In Reply to: Re: Trailer for tractor posted by Bama Binder on October 02, 2000 at 12:42:49:
The only way you can get the wheels on an M less than 7 ft out to out is to turn the wheels so the concave side is facing in. My MD has the wheels all the way in with the concave out and it is 85 inches out to out of the tires. I agree that a 7000 lb trailer is not enough for an M. You need at least a 10,000 lb. But you can go up to 10,000 lbs gross weight with a class three hitch if you use an equalizer hitch. I also think a 318 engine is to small to be pulling an M around much. Short trip only!! I have the same problem and have been looking at trailers. I've concluded that the only way to go (without turning the wheels, which I do not want to do. Don't think they look right that way) is a goose neck over the wheels with an 8 ft wide bed. With the hitch and the trailer, you are looking at around $4K to get set up! I'm lucky, I already have the enough truck to pull it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|