I felt the same way when I began working on the M that my wife inherited after her father past. I married into a farming family (im a teacher and my wifes a banker but grew up farming) so I had no clue about tractors either, I did have a basic knowledge of how engines work but i had never worked on them. What I can tell you is that I have learned a great deal from the gentlemen on this site and just diving right in. I know that an M is a pretty basic and easy machine to work on and my brother in law has a 560 and he says its not much more difficult than my M...Just remember that there is no such thing as free, im finding that out right now as I diganose an engine problem, BUT it is a lot of fun.
My advise, learn as much as you can about Farmall 560's, read-research-ask questions, then go to your 560 and check to make sure your engine is not stuck, check power going to the entire electrical system with a good battery, make sure you have fuel moving through the carb, make sure the starter is not stuck, and make sure you have a very good ground from the battery. Once you get it running you'll be hooked, trust me!! Id also pick colby's brain a bit, hes doing one hell of a job on his 560!! Best of luck....~Anthony
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.