Farmall & IHC Tractors Discussion Board |
Re: Re: oil pressure on Cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george on October 02, 2000 at 11:11:43 from (209.9.254.221):
In Reply to: Re: oil pressure on Cub posted by Andy Martin on October 01, 2000 at 19:07:28:
Andy: Perhaps I misunderstood, but the oil pump is not in the pan in the Cub...it's behind the flywheel and accessed only by splitting the tractor. Two gears spin in a housing there. Most likely loss of pressure is worn crank/cam bearings. Robbie: One thing to check/replace is the oil pressure regulator spring and seal. It is behind a large hex plug on the right side, near the front, of the engine. I have been experiencing a similar problem, replaced the spring and seal, and picked-up some pressure. Also, swithch to 15-w40 oil or use an additive. If you do pull the pan, the oil pick-up screen should be cleaned. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|