Posted by D Slater on July 06, 2012 at 04:27:32 from (184.15.36.245):
In Reply to: Re: Hello, first post posted by Patrick HMD on July 05, 2012 at 21:51:37:
Venturi will only fit correct one way. If I understand the description correct, venturi is installed correct. They stick inside the throttle body sometimes. On realy stuck ones I remove the throttle shaft and drive them out the bottom of the throttle body. Old wood broom handle sawed off with a rounded end to venturi works good to do it without damage. Don't know if this is the reason for the float damage, but thats something that can happen if a air hose is used to blow through the carb inlet for a fuel flow problem by someone uninformed. Or float was rubbing the bowl and they just mashed it in to clear instead of doing it right. Front bolster is the reason for the hood being to short. It moves the radiator around 1.5 inches farther forward or away from the engine than a M gas bolster.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.