Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Rob Johnson -W6
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by robert on October 01, 2000 at 17:04:27 from (202.72.131.105):
In Reply to: Re: Re: Rob Johnson -W6 posted by Rob Johnson on October 01, 2000 at 01:36:01:
As far as I can remember the splines etc were good and tight,Freight would be a killer from over here.I will take the loader up and check them.Having same problem as you in finding rubber 13.50x 28 hard to get may go with 16.9 x28 as these are more readily available S/H eg chamb combine & massey 80. The AW6 came with a W6 I bought the W6 was complete & running.Somebody had used it for bits. I am based at Quairading 100miles east of Perth
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|